If your whirlpool cabrio washer will fill with water but won t spin the lid lock switch is probably bad.
Whirlpool cabrio washer lid lock override.
If it still won t budge proceed to plan b.
Step 4 put the lid back down and plug the washing machine back into the electrical outlet.
Ask your own appliance question.
Most washing machines come equipped with a lid switch.
If it opens you re all set.
If the lid will not lock and keeps clicking on your whirlpool cabrio washer it is probably a faulty lock switch assembly.
Under operation start with the new switch in the off position then start the machine wash cycle as you would normally do wait a couple of seconds and then hit new switch so that it is in the on position.
Then connect the red wire to the blue and white wires and wash cycle should begin.
If you leave the lid.
This switch is connected to a solenoid that completes a circuit allowing the machine to run only if the top is.
The lid lock mechanisms on some washers are heat activated which means overriding them is as simple as letting them cool off.
Let the washer sit unplugged for about 10 minutes then try lifting the lid.
There should be an object on the edge of the lid and a hole on the edge of the opening.
Connect the blue and white wires start a load and wait until the lid lock red light comes on.
Look for the lid lock switch on the underside of the top panel and where it fits into the appliance.
Whirlpool cabrio lid lock step by step instructions on how to replace a lid latch assembly w10404050 for washer you can not bypass these locks and.
Then connect the lid lock open wire to the off pole of the switch and the lid lock closed wire to the on pole of the switch.
You will need to take a look at the lid lock assembly and see if there is a visible issue with it possible electrical issue or possibly something else may be causing the issue.
This is one of the most common problems with direct drive washing machines.
Place a magnet between the two so there is a magnetic connection between the lid lock and the solenoid inside the washer.
When you close the lid the object goes into the hole and presses a lever or button.
