I checked the output to the hall effect sensor at the board which you need to have the oven plugged in and running to do this test contrary to the code sheet troubleshooting instructions and it was 5v dc.
Whirlpool hall effect sensor.
7 plug in range or reconnect power.
3 people found this helpful.
Cooling fan speed too low fan speed below 500 rpm either because the fan is spinning too slowly or because there is a problem with the hall effect sensor.
The hall sensor also known as the rotor position sensor rps is part of the automated system of your washing machine.
8 start a cook cycle and check for proper operation.
Jose for model number kp26m1xmr.
Check the hall sensor by removing the control board p7 connector and testing for 5 vdc between p7 7 and p7 1.
As the element heats the sensor senses the ambient temperature inside the oven.
So for giggles i checked the output of the hall sensor to the board while running and it was barely 1 volt dc.
Range oven blower motor with hall sensor.
So far so good.
Start a cook cycle and check for proper operation.
It helps the control board make sure that everything is running as it should.
The whirlpool oven sensor protrudes from the rear wall of the oven and connects to the oven thermostat.
If test results are not correct replace the hall sensor.
If test is good go to step 6.
7 plug in range or reconnect power.
Pull the range forward and remove the top access cover.
If test is good go to step 6.
If test results are not correct replace the hall sensor.
This is a new genuine whirlpool replacement part.
Plug in range or reconnect power.
Top rated repair story eric from nc.
5 check the hall sensor by removing the control board p7 connector and testing for 5 vdc between p7 7 and p7 1.
Whirlpool brands include whirlpool maytag kitchenaid jenn air amana magic chef admiral norge roper and others.
6 replace all parts and panels before operating.
If test is good go to step 6.
5 check the hall sensor by removing the control board p7 connector and testing for 5 vdc between p7 7 and p7 1.
Replace all parts and panels before operating.
Manufactured by whirlpool oem.
Manufacturer part w11107275.
If test results are not correct replace the hall sensor.
Part number pd00037690.
6 replace all parts and panels before operating.
8 start a cook cycle and check for proper operation.
Finally figuring out a way to test the hall sensors without taking the motor apart.
Does the hall effect sensor included on the speed control assembly.
