The water inlet valve on your washing machine is used to fill the tub with cold warm or hot water for the wash and rinse cycles.
Whirlpool washing machine water inlet valve leaking.
I discovered a way to repair the dripping water from the solenoid valves in my washing machine.
Will not spin the load or fill up with water.
This video provides step by step repair instructions for replacing the water inlet valve on a whirlpool washer.
Step by step instructions on how to replace a water inlet valve 285805 for washer washer dryer combo made by whirlpool roper kenmore maytag estate crosley.
My whirlpool cabrio washing machine clicks while trying to sense the load in the beginning.
The most common reasons for replacing the wat.
The water inlet spout is a small plastic part located within the machine s main basket.
There are two ports for water to enter and this valve is compatible with a half inch id hose.
I could find no information on the net as to a repair just.
The washer has a water leak that sjows up at right front corner when washer used.
If there isn t any water in the tub you have a leaking water inlet solenoid valve in the washer.
Water leaves a poola bout 10 diameter.
This part could have either a blue or green colored valve body.
If a problem is found the spout should be replaced promptly.
If your whirlpool duet washer is leaking ensure that this piece is fully attached to the machine and free of any cracks or damage.
The water inlet valve can sometimes malfunction due to burnt coils.
A problem with the valve can cause the washer not to fill properly or not fill at all.
They cannot be repaired they have to be replaced.
There is little that you can do to repair the valve itself but you can clean the two inlet ports to restore full water flow.